Vapor Barriers

Thinner membrane types come in rolls or as integral parts of building materials. Common examples include polyethylene sheeting and aluminum, or paper-faced fiberglass roll insulation. Another type is foil-backed wallboard. Most paint-like coatings also retard vapor diffusion.

Installing Vapor Diffusion Retarders for new buildings

In mild climates, materials like painted gypsum wallboard and plaster wall coatings may be enough to impede moisture diffusion. In more extreme climates, higher-perm vapor diffusion retarders are advisable for new construction. They perform best when installed closest to the warm side of a structural assembly – toward the interior of the building in cold climates and toward the exterior in hot/ wet climates.

A vapor diffusion retarder installation must be continuous and as close to perfect as possible. This is especially important in very cold climates and in hot and humid climates. Be sure to completely seal any tears, openings, or punctures that may occur during construction. Cover all appropriate surfaces or you risk moist air condensing within the cavity, which could lead to dampened insulation. The thermal resistance of wet insulation is dramatically decreased, and prolonged wet conditions will encourage mold and wood rot.

Installing Vapor Diffusion Retarders in Existing Buildings

Except for extensive remodeling projects, it’s difficult to add materials like sheet plastic as a vapor diffusion retarder to an existing building. Obtaining an energy audit and thoroughly sealing any leaks it reveals is a very effective strategy for slowing moisture movement in and out of the building.

The building may not need a more effective vapor diffusion retarder than the numerous layers of paint on its walls and ceilings unless you live in extreme northern climates. “Vapor barrier” paints can be an effective option for existing homes in colder climates. If the perm rating of the paint is not indicated on the label, find the paint formula. The paint formula usually indicates the percent of pigment. To be a good vapor diffusion retarder, the paint should consist of a relatively high percent of solids and thickness in application. Glossy paints are generally more effective vapor diffusion retarders than flat paints, and acrylic paints are generally better than latex paints. When in doubt, apply more coats of paint. It’s best to use paint labeled as a vapor diffusion retarder and follow the directions for applying it.

Combination Air Barriers, Vapor Diffusion Retarders

An air barrier/vapor diffusion retarder attempts to accomplish water vapor diffusion and air movement control with one material. This type of material is most appropriate for southern climates where keeping humid outdoor air from entering the building cavities is critical during the cooling season.

In many cases, air barriers/vapor diffusion retarders consist of one or more of the following materials:
• Polyethylene plastic sheets
• Builder’s foil
• Foam board insulation
• Other exterior sheathings.

Air barriers/vapor diffusion retarders are generally placed around the perimeter of the building just under the exterior finish, or they may actually be the exterior finish. The key to making them work effectively is to permanently and carefully seal all of the seams and penetrations, including around windows, doors, electrical outlets, plumbing stacks, and vent fans.